SPEED7-TECHNOLOGY - compatible SIEMENS S7-300®

VIPA CPUs and peripheral modules with the instruction set S7-300® by Siemens are more than 20 times faster than the similar S7-300® products. VIPA offers SPEED7, the technology of tomorrow, based on a million times proven STEP®7-programming platform. A flexible memory management covers all possible applications from 64kByte to 1MByte. Program and data are stored in one memory, no extra loading memory is necessary. A pluggable MMC/SD-Card-Card allows configuration as well as project and data saving in a FAT16 format compatible with PC.
Ethernet for PG communication, online maintenance and OP communication are always on Board (PtP). The well known serial system bus from the S7-300® series by SIEMENS is completely supported and allows the use of the S7-300® units of SIEMENS and VIPA. All important certifications exist. The complete STEP®7/S7-300® command set is available and was tested for full accuracy, examined from an independent Test institute in extensible test rows.

VIPA MCC offers the possibility to extend the RAM of Speed7 CPUs. The MCC is a specifically prepared MMC (multimedia Card). Plug the MMC into the card slot and execute an overall reset and the extension becomes available. The MCC must remain plugged in, otherwise the CPU switches to STOP after 48 hrs.
The MCC cant be exchanged to a MCC with the same memory configuration, but it can be used for the project backup (Copy RAM > ROM). The shown MCC memory value increases the already available basic memory of the CPU by the value of the card. However, the maximum memory shown of the CPU cant be overridden, even if a bigger memory extension is plugged in.

All cards have a minimum capacity of 512MByte and can be used additional for programm backup.

VIPA 953-0KX10
MMC flashcard, 512MByte, only for program back up, recommended if no MCC-Card is used.

VIPACPUs and peripheral modules with instruction set S7-300®/S7-400® by Siemens are faster than the currently strongest S7-300®, S7-400® systems. VIPA offers Speed7, the technology of tomorrow, based on a million times proven Step®7-programming platform. A flexible memory management covers all possible applications from 64kByte to 8MByte. Program and data are stored in one memory, so no extra loading memory is necessary. A pluggable MMC/SD-Card allows configuration as well as project and data security in a FAT16 format compatible with PC.
PROFIBUS-DP master or optional master CANopen and Ethernet for PG communication, on-line maintenance and OP communication are always on Board (PtP). In addition, an EthernetCP is able to become integrated directly into the CPU cabinet, compatible with CP343, 10/100Mbps.
The well known serial system bus from the S7-300® series by Siemens is completely supported and allows the use of the S300® units of SIEMENS and VIPA. Not only are 8 modules able to be switched on, but also the CPUs support to drive up to 32 modules in a line.
All relevant certifications exist. The complete Step®7/S7-300®/400®er command set is available and has been examined by an independent test institute in